- The V-Band design aluminum mounting clamp gives a very clean and unique appearance. The clamp is anodized and uses Stainless Steel hardware for a long lasting, corrosion-free appearance.

- The valve seal utilizes a Viton O-ring that is clamped in place to prevent the possibility of sticking to the seat and pulling out. The valve stem and guide are nylon-lubricated, hard anodize-coated for wear resistance.

- The Blow Off Valve also comes with our own machined aluminum banjo-type air fitting and bolt, with over sized 10mm hose barb for quick actuator response. The actuator has a high temp silicone Nomex-reinforced diaphragm for long life.

- An aluminum, mild steel, or stainless steel base mounting flange is available at an additional cost. The use of 6061 aluminum allows the housing to be anodized with a selection of colors.

- Through countless hours of R&D we were able to make the same size valve flow a staggering 60% more than the original design - that means 60% more air is blown off per cycle! This is the highest flowing BOV on the market.

These come with a pre-installed 11 psi spring. Extra springs can be bought seperately.

Included with Every TiAL BOV:

TiAL BOV Assembly

TiAL V-Band Clamp

High Pressure O-Ring

TiAL Air Fitting

This blowoff valve is rated to flow 60% more then the previous TiAL valve.